NAPA survey shows spike in warm-mix asphalt use

July 18, 2018

In 2017, nearly 39% of all asphalt pavements were produced as energy-saving warm mix nationwide

Nearly 39% of asphalt pavement mixture produced in 2017 was produced as warm-mix asphalt at reduced temperatures, which decreases energy demands, reduces air emissions, and improves compaction at cooler temperatures, according to the latest survey report from the National Asphalt Pavement Association (NAPA).

The latest survey of asphalt mix producers finds that more than 99% of the asphalt pavement material removed from roads and parking lots in 2017 was put back to productive use, primarily in new asphalt pavement mixtures.

The survey of the U.S. asphalt pavement mixture production industry has been conducted for each construction season since 2009 by NAPA in partnership with the Federal Highway Administration (FHWA). Over the years, the survey has documented increases in the use of recycled materials and warm-mix asphalt.

In 2017, 147.4 million tons of warm-mix asphalt was produced at reduced temperatures—nearly 39% of total asphalt pavement mix production, and a 777% increase since 2009.

The use of warm-mix asphalt had tracked at about a third of all asphalt mixture production since 2013. The increase for 2017 is attributable to an increase in the tons of warm-mix asphalt used by state departments of transportation (DOT). Companies that produce warm-mix asphalt reported that about 42% of the asphalt pavement mixture produced for DOTs was produced at reduced temperatures using warm-mix technologies.

Also, according to the survey, nearly 79 million tons of recycled materials—primarily reclaimed asphalt pavement material (RAP) and recycled asphalt roofing shingles (RAS)—were used in new asphalt pavement mixtures during the 2017 construction season, which was similar to the amount of these materials used in 2016. Ground tire rubber, steel and blast furnace slag, and recycled cellulose fibers were among the other recycled materials used in new asphalt pavements in 2017. The use of RAP and RAS alone resulted in cost savings of more than $2.2 billion compared to the use of virgin materials.

The survey found that more than 76.2 million tons of RAP and nearly 950,000 tons of RAS were used in new asphalt pavement mixes in the U.S. during 2017. An additional 3.9 million tons of RAP and RAS were used as aggregate, in cold-mix asphalt, and other road-building activities.

The survey also found that at year-end 2017 about 103.5 million tons of RAP and RAS was stockpiled for future use across the country. Reclaiming RAP for use in future pavements saved nearly 50 million cu yd of landfill space during 2017.

Although national usage estimates were not calculated, respondents to the survey reported recycling some 1.5 million tons of ground tire rubber, slags, cellulose fiber and other reclaimed and waste materials into nearly 7.5 million tons of asphalt paving mixtures.

----------

Source: NAPA

Sponsored Recommendations

The Science Behind Sustainable Concrete Sealing Solutions

Extend the lifespan and durability of any concrete. PoreShield is a USDA BioPreferred product and is approved for residential, commercial, and industrial use. It works great above...

Proven Concrete Protection That’s Safe & Sustainable

Real-life DOT field tests and university researchers have found that PoreShieldTM lasts for 10+ years and extends the life of concrete.

Revolutionizing Concrete Protection - A Sustainable Solution for Lasting Durability

The concrete at the Indiana State Fairgrounds & Event Center is subject to several potential sources of damage including livestock biowaste, food/beverage waste, and freeze/thaw...

The Future of Concrete Preservation

PoreShield is a cost-effective, nontoxic alternative to traditional concrete sealers. It works differently, absorbing deep into the concrete pores to block damage from salt ions...