EPA finalizes new off-road diesel engine standards

May 14, 2004
The U

The U.S. Environmental Protection Agency (EPA) finalized new standards May 11 on the exhaust emissions of off-road diesel engines primarily in the construction, agriculture and industrial sectors. The Phase IV standards will take effect starting in 2008 for engines less than 25 hp and will be fully phased in by 2014 for larger engines.

The U

The U.S. Environmental Protection Agency (EPA) finalized new standards May 11 on the exhaust emissions of off-road diesel engines primarily in the construction, agriculture and industrial sectors. The Phase IV standards will take effect starting in 2008 for engines less than 25 hp and will be fully phased in by 2014 for larger engines. EPA estimates that the new standards will add an additional cost to manufacture off-road equipment. For example, EPA estimates the cost of a new 175-hp bulldozer that currently costs about $230,000 will increase in price by about $2,600 to add the advanced emission control systems to the engine and to redesign the equipment to accommodate the modified engine.

EPA also will require major reductions in the amount of sulfur contained in off-road diesel fuel. Currently, sulfur in off-road diesel is at about 3,400 parts per million. The new rules would require that level to drop to 500 ppm by 2007 and then to 15 ppm by 2010.

Originally, EPA and several environmental groups had been advocating that off-road diesel fuel also drop to 15 ppm by 2007. However, ARTBA and several other industry groups persuaded EPA to phase in the fuel requirements over a longer period of time in order to avoid fuel shortages. Even without any shortages, EPA estimates that off-road diesel will increase about a nickel a gallon by 2010 due to higher refining costs to lower the sulfur content.

The proposed regulations also contain provisions to help mitigate the economic costs of meeting the new standards. They provide extra time for small engine manufacturers and small refiners to meet the new standards. The regulations also provide incentives for earlier compliance and allow companies to petition EPA for relief of the burden if the regulations would cause severe economic hardship.

Sponsored Recommendations

The Science Behind Sustainable Concrete Sealing Solutions

Extend the lifespan and durability of any concrete. PoreShield is a USDA BioPreferred product and is approved for residential, commercial, and industrial use. It works great above...

Proven Concrete Protection That’s Safe & Sustainable

Real-life DOT field tests and university researchers have found that PoreShieldTM lasts for 10+ years and extends the life of concrete.

Revolutionizing Concrete Protection - A Sustainable Solution for Lasting Durability

The concrete at the Indiana State Fairgrounds & Event Center is subject to several potential sources of damage including livestock biowaste, food/beverage waste, and freeze/thaw...

The Future of Concrete Preservation

PoreShield is a cost-effective, nontoxic alternative to traditional concrete sealers. It works differently, absorbing deep into the concrete pores to block damage from salt ions...