Worker protection from respirable silica difficult even with controls, says study
Feb. 7, 2019
Chipping and crushing activities were cited in the study as particularly dangerous
A study conducted by researchers at the Department of Health at the University of Massachusetts-Lowell has concluded that dangerous levels of respirable silica are difficult to control during chipping and crushing activities even when dust control measures are in place. The study cites risk for both workers and bystanders.
The study analyzed more than 80 combined worker and bystander breathing zone air samples at multiple construction sites across the state of Massachusetts during chipping and crushing operations. Chipping workers and crushing machine operators were shown to have the highest exposure to respirable silica, with levels above the Occupational Safety and Health Administration’s (OSHA) permissible exposure limit (PEL) within 15 minutes to two hours for chippers — even with cartridge respirators — and crushers, respectively.
At present, OSHA has sought public input for a potential revision of its Table 1 recommendations, but it remains unclear how swiftly change might occur, if at all.
For more detailed information on OSHA’s current regulations as well as a comprehensive chart outlining them in detail, read the article, “Up for revision," in our February issue.
Extend the lifespan and durability of any concrete. PoreShield is a USDA BioPreferred product and is approved for residential, commercial, and industrial use. It works great above...
The concrete at the Indiana State Fairgrounds & Event Center is subject to several potential sources of damage including livestock biowaste, food/beverage waste, and freeze/thaw...
PoreShield is a cost-effective, nontoxic alternative to traditional concrete sealers. It works differently, absorbing deep into the concrete pores to block damage from salt ions...
